Before attaching surround assembly, check operation of insert and installation of draft hood and chimney liner.
To assemble surround attach panel (A), (B), (C), and (A1) if Picture Frame was purchased) with bolts
(10/24) and star lock nuts, if optional brass panel kit was purchased install at this time over the surround kit and
tighten the bolts to secure all panels.
All brass trims (D), (E), and (F) are installed with 5/16 x 6/32 self tapping screws, attach part (D), (E) and (F) to outer
edge of surround. Than place On/Off switch into slot (upper right corner) after trim has been attached to surround.
Route wires through 3/4” grommet hole, down right side of surround into right side of insert. A hole is provided in
blower intake box to route wires over to the valve, attach at TP and TP- TH.
(Refer to Wiring Diagram Section
20
)
14. Surround and Brass Trim Assembly Instructions (Three Piece Surround & Picture Frame)
22
