VFI25/VFI30 Conversion Kit Instructions – PART A
1. Lift ember plates out of burner area. Remove screws from burner hold downs. Slide main burner to the left, and lift out
of fireplace insert.
2. Adjust the Air Shutter to the correct Primary Air setting as specified in the manual or on the label plate. To adjust the
Primary Air setting, loosen screw on the side of the Air Shutter and rotate to the correct opening using a drill bit or
tape measure. Retighten screw.
3. Remove the Main Orifice using a ½” wrench and replace with the new Conversion Orifice which came with the
Conversion Kit.
4. Replace the Burner Tube. Install the new Pilot Orifice (See
Pilot Conversion
) and Hi/Lo valve regulator by following
instructions supplied with the Conversion Kit.
IMPORTANT: Always check for gas leaks with a soap and water solution. DO NOT USE OPEN FLAME FOR LEAK TESTING.
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction.
If the information in these instructions is not followed exactly, a fire, explosion or production of carbon
monoxide may result causing property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The installation is not proper and complete
until the operation of the converted appliance is checked as specified in the manufacturer's instructions
supplied with the kit.
Caution
: The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding
with the conversion.
14
