IDV33 / IDV36
Burner Installation/Removal
Burner System
1. Remove glass door assembly and logs (if
installed). Be careful with logs as they become
fragile after being heated.
2. Remove log supports off burner assembly.
3. The burner or burner assembly can now be
removed.
a. TO REMOVE H-BURNER/ORIFICE
CHANGE - Remove the two [2]
screws holding the H-Burner in and
slide it leftwards off the orifice.
b. TO REMOVE BURNER ASSEMBLY -
Locate and remove the twelve [12]
screws around the outside of the
burner pan. This will remove the entire
burner assembly.
4. When removing the entire burner assembly,
break the seal and lift upwards. Make sure the
gas line to the unit has been disconnected.
5. To reinstall the burner assembly ensure the surfaces are cleaned, and old sealant material removed. Use high temp
Millpac to seal and secure with the twelve [12] screws.
6. Reconnect the gas line, and reinstall log support, logs, and glass door.
IDV26
Burner
Installation/Removal
Remove glass door assembly and logs (if installed).
Be careful with logs as they become fragile after
being heated.
Remove log supports from burner assembly.
The burner can now be removed.
TO REMOVE H-BURNER/ORIFICE CHANGE -
Remove the two [2] screws holding the H-Burner in
and slide it leftwards off the orifice.
TO REMOVE ENTIRE BURNER ASSEMBLY
, see
next page.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
38
