Kingsman Fireplaces ZCV3622LP, Installation Instructions Manual

Page: 25 / 79

Liner Installation Guide - ZCV3622PRL / ZCV3622ML for ZCV3622 Units
- Z3622PRL / Z3622ML for ZCVRB3622 Units
1. Make note of the position of the air adjustment plate before removing it. This position will have to be recalled when the air
adjustment plate is reinstalled.
2. Remove three [3] mounting screws from air adjustment plate and extract it from the firebox. (NOTE: The false bottom will have to
be removed on model ZCVRB3622.)
3. Remove the [1] Liner Retaining Screw from each side of the firebox. These screws will be reused for installation of the side liner
panels.
4. Place the rear liner panel against the back of the firebox. When placing the panel, tilt it towards you while lifting it over the burner
assembly.
5. To place the side liner panels, rotate panel towards you while placing the bottom edge over the front ledge of the firebox. Then,
rotate the panel upright and slide it back towards the rear liner panel. Make sure the top of the side panel is engaged with the top of
the rear panel as shown in the illustration below. Once all the liner panels are installed, ensure they are sitting flush to the walls of
the firebox.
6. Reinstall the air adjustment plate back to its original position. (NOTE: Only for instances where the adjustment plate is in the
extreme up position, it is not necessary to reinstall the plate. One may prefer not to install the plate for a more finished
appearance.)
7. If applicable, reinstall the false bottom.
Liner Retaining Screw
Note: Warping and Discoloration of Porcelain or Painted Metal Liners Is Not Covered Under Warranty.
Both Porcelain and Painted Metal Liners may discolor and warp during normal operation of your appliance. This is
normal, and not considered a defect
.
False Bottom
(ZCVRB3622)
25