ZCVRB47
Door and Glass Information
Glass Cleaning
It will be necessary to clean the glass periodically. During start-
up, condensation, which is normal, forms on the inside of the
glass and causes dust, lint etc. to cling to the glass surface. Also,
initial paint curing can deposit a slight film on the glass. It is
therefore recommended that initially the glass be cleaned two or
three times with non-abrasive common household glass cleansers
and warm water. After that, the glass should be cleaned two or
three times a season depending on the circumstances.
Glass Replacement
REPLACEMENT GLASS FOR DIRECT VENT UNITS
Model Series ZCVRB47 must use tempered glass.
Must be 5mm thick.
To replace glass,
1. Clean all materials from door frame.
2. Scrape off old silicone down to metal.
3. Using a high heat silicone temperature-resistant to 500°F
(260°C) apply a continuous bead of approximately 1/4” to
all four sides of frame and insert glass with new gasket.
Frame should be on flat surface with a small amount of
weight pressing glass into silicone. Let dry approximately
15 to 20 minutes.
4. Use caution when removing broken or damaged glass.
Wear gloves.
Removal of the Glass Door ZCVRB47
1. Remove the door by unlatching the 2 top latches.
Simply place 2 fingers in the grooves, pull towards
you and lift upwards slightly.
2. Once the top of the door is unlatched, simply pull
outwards and lift upwards to unlatch the bottom.
3. When re-installing the door place the bottom of the
door in first and secure with Top Latch assembly to
the door.
Spring Replacement: ZCVRB47
*Over time, spring may need to be replaced if tension is lost.
1. To remove the top latch, remove the 2 hex screws
that secure it in place. They are located in the firebox.
2. Once all the screws are removed the latches will slide
out of place.
3. There is 1 lock nut per latch. When replacing a spring,
tighten the lock nut until 2 threads are beyond the
locknut. This is critical for proper tension.
⚠
Warning and Cautions
• Do not clean when the glass is hot.
• Do not use abrasive cleaners.
• Using a substitute glass will void all product
warranties.
• Do not strike or abuse glass. Care must be taken to
avoid breakage of the glass.
• Do not operate this fireplace without the glass front or
with a broken glass.
2 HEX SCREWS
SPRING PART
#
36HB-123
36
