Kingsman Fireplaces IDV24, Installation Instructions Manual

Page: 26 / 57

IDV24 Glass Door Information
Glass Cleaning: During normal startup condensation will form, causing dust and lint to cling to the surface of the glass. A
commercial fireplace glass cleaner can be used two or three times a season, depending on use of the appliance.
⚠
WARNING AND CAUTIONS
•
Do not clean when the glass is hot.
•
Do not use abrasive cleaners.
•
Using a substitute glass will void all product warranties.
•
Do not strike or abuse glass. Care must be taken to avoid breakage of the
glass.
•
Do not operate this fireplace without the glass front or with a broken glass.
REPLACEMENT GLASS
Only Robax ceramic or coated NeoCeram
glass may be used for replacement. The
glass must be a minimum of 5mm thick.
⚠
WARNING:
No substitute materials may be used
other than factory supplied
components.
Spring Replacement: Over time the spring may need to be replaced if tension is lost. Replace spring as follows:
1. Remove the top latches by unfastening the two [2] hex screws that secures it in place. They are located in the firebox.
2. Remove the bottom latches by unfastening the four [4] hex screws located in the firebox (beside the burner assembly).
Once the screws are all removed, the latches will either fall or slide out.
3. To remove the spring, unfasten the one [1] lock nut holding it in place. NOTE: When replacing a spring tighten the lock
nut so that the total compression length is 3-1/2". This is critical for proper tension
.
IDV24 Glass Door Removal and Installation
1. Disengage Top Latches by pulling on Latch Pull with one
hand and pushing up on Latch Pull with the thumb of your
other hand (See Photo to left).
2. Once the top of the door is unlatched, pull it outwards and up
to unlatch the bottom.
3. To re-install, place the Bottom Door Ledge into the Lower
Latch assembly first. Then swing the door closed to seal it
against the firebox cavity.
4. To re-latch the Upper Latch assembly, Pull on Latch Pull
with one hand and push up with other hand. Lift Latch over
Door Hook and allow Latch Hook to drop down over the
Door Hook.
Latch Pull
To Disengage Top Latch:
TO REPLACE GLASS:
Clean all materials from door frame. Using a high heat
silicone (resistant to 500°F [260°C]) apply a bead of
approximately 1/8” to all four sides of frame and insert
glass with new gasket. The door frame should be on a flat
surface with a small amount of weight pressing the glass
into the silicone. Let everything dry for approximately 15
to 20 minutes.
Top Hooks
Bottom Door Ledge
Bottom Latch
To Reinstall Glass Door:
26