ASSEMBLY and INSTALLATION continued...
6
24.
Make sure that the fabric is pulled over
all corners of the end bows.
Figure 23
25.
Open the canopy by releasing the four
cam leavers at the bottom of the legs and
pulling out the two end bows.
26.
With the canopy now open make sure
that the top sides come down an equal
amount past the press studs on both
sides.
Figure 24
27.
Now fully tighten the 4mm x 40mm
Button head screws connecting the top to
the main bow.
28.
With the side stretched over the press
stud mark out the position with a pencil.
Figure 25
29.
Take a Stanly knife and cut a 5mm cross
in the fabric for the press stud.
NOTE:
Cutting this while stretched over the
press stud will help prevent over cutting
the fabric.
Figure 26
30.
Put the snap part of the press stud into
press stud base already on the frame.
Figure 27
Now place the stem of the cap
through the fabric and line up with the
hole of the press stud.
Figure 28
Using a
hammer join the two haves together.
Fig-
ure 29
31.
With the top open screw the fabric to the
frame in each corner through the plastic
inserts with the 8g 1/4” self tapping
screws.
Figure 30
32.
NOTE: If the press stud is too loose this
can be fixed by placing some thin plastic
in between the press stud base and Stud.
Figure 31
Figure 23
End Bow Knuckles
Figure 24
End Bow Knuckles
Figure 25
Press Stud
Figure 26
Press Stud Cutting
Figure 27
Press Stud
Figure 28
Press Stud
Figure 29
Press Stud
Figure 30
Corner Screws
Figure 31
Press Stud
