ASSEMBLY and INSTALLATION continued...
2
FRAME ASSEMBLY:
1.
Locate all of the Frame components
(Part N° 1,2 )
Figure 1
2.
From bag
A
containing the black
plastic parts remove the four joining
knuckles. Using the 8G x 1/2” pan-
head, screw the joining knuckle
marked “A”
(
Figure 2)
To each of the
bent main bow pieces (Part N° 1)
making sure that the nut recess is
facing outward and the screw head
is inwards.
(
Figure 3)
NOTE: The holes
might need to be drilled out with a
3.5mm drill bit.
4.
Attach the joining knuckles labeled
“B”
(
Figure 2)
to the top of the
straight components. (Part N°2)
(
Figure 3 & 4)
Making sure to line up
the hole in the knuckle with the pre
drilled hole in the aluminum tube
and that the nut recess is facing out-
ward. You should have a mirror pair
of canopy ends.
Figure 4
5.
Screw the four plastic press studs to
the out side of the main bow legs
using the supplied countersunk 8G
screws.
Figure 5
6.
Screw the 4 stays (Part N° 7) to each
joining knuckle.
You should now have two halves
which look the same as
Figure 6
7.
Slide on the 4 sliding knuckles to the
bottom of the legs (Part N° 1 & 2)
with the nut recesses facing out-
wards.
Figure 6
Figure 1
Frame components.
1
1
2
2
Figure 2
Joining Knuckles
A
B
Figure 3
“A” Frame and Joining
knuckles
Figure 5
Stayput Press Studs
Figure 6
Complete Frame End
Stays
Sliding Knuckles
Figure 4
Frame Ends
