3, OPERATION GUIDE
Pos. 1 (lighting/pilot)
Pos.2
(Max)
1) LIGHTNG INSTUCTION
a)
The heater has two settings. Lighting/Pilot(Pos.1) and Max (Pos.2)
b)
Place the gas filled cylinder into the back of the heater. and Fix the back cover by
tightening the screws.
c)
Clip on the gas regulator to the gas cylinder.
d)
Turn on the gas regulator.
2) LIGHTING
a)
Press the control button for 30-60 seconds at the Position 1, at the same time
press the Igniter key to lit with thumb finger of left hand, Continue this
procedure until pilot ignites, approximately after 20 seconds leave control
button. At this stage if the pilot is alight, If the pilot flame goes out please repeat
this procedure. and then turn the knob to Pos.2. to Max power setting,
3) HEAT SETTINGS
a)
The thermostat temperature adjusting range is between 7 - 32
℃
.
b)
Turn the small thermostat knob anticlockwise to position from "
一
" to"+" to set
temperature. When the room has reached the desired temperature(4
℃
higher
than the setting temperature), the burner will go off automatically, the pilot will
keep lighting all the time, and while the room drop approx. 4
℃
lower than the
setting temperature, the burner will restart automatically. In this way, the
appliance will automatically maintain the set temperature by cycling.
c)
In the event of "burn back" turn off and try again. Should it happen a second time,
return the unit to the dealer.
7
