I
11. Elevator servo and linkage installation :
Pushrod
Clevis�
=-----------------
First you need to make a small cut in the film covering material for the pushrod exit. In order to do this
neatly, gently insert the supplied q>0.9 mm piano wire (Non clevis side) into the pushrod sleeve in the
radio compartment and slowly feed the piano wire until it touches the flim covering. This will let you know
exactly where the pushrod exit is at the rear of the fuselage. Next get a hobby blade to make a small cut
in the film covering and let the wire exit from the opening. Finally, link up the elevator control horn with the
clevis and perform a test by hand to see if the movement is free from any restriction. Adjust the wire as
necessary by bending if need be to ensure as little friction as possible in the push rod.
14
Note: Ensure the travel range of the elevator
is symmetrical.
__ .,,,y··
•. :::-..._."
►
Note: Ensure the travel range of the elevator
is free from any binding.
Side View
Recommend Elevator and
Rudder servo spec:
Torque: <3.5 kg/cm
Speed: > .16 secs/60 degree
Operating Voltage Range:
4.8-6.0V
Top
View Max
14 m:m
�I
□
«��
