I
4. Wing installation:
To assemble the top three wing
get er
wing section and ensure it is centered. Then slid
tube as shown.
490mm
0
0-
-
-
-
®
Insert #5 and #6 metal fittings into their slots with
one in the front and one in the rear respectively.
Please note the orientation of the metal fittings
by referring to the diagram shown above. If
some of their slots are too tight and also hard to
get the fittings fully seated use a needle file to
clean any burrs from the fittings or glue residue
in the slots to achieve the best possible fit.
Upper wing bottom
------
6
re.,
1400MM
BALSA ARF
>
hex screws
Lock both
els in place b
using the
x screws, use
After double checking all the fittings are in the
right place and in the right orientation as per
the picture shown above. You may use epoxy
glue to permanently bond them in place.
