Kingarden LS10TG, Instruction Manual

Page: 13 / 19

13
using smaller container make sure to drain the more than one round to avoid splitting old oil out
on the ground. Used oil is very polluting and should be disposed in accordance with local rules.
After refilling the tank with new oil, let the splitter cycle three or four times and let the air blow out
of the hydraulic loop before closing the cap.
5.3 Ram sliding pads
Should irregular noisy knocks be heard while ram is sliding up and down, grease the plastic
sliding pads located inside the sliding ram casing. Preferably use commercial grease available in
your country.
Make a trial test before starting to work again. The noisy knock should disappear after
greasing.
Should you detect an unusually large gap between sliding ram casing and the guide, sliding
pads are likely to be worn out. if so replace them with brand new ones.
6.Technicai specifications
Model number LS10TG
Log capacity 550/820/1040mm
Min log diameter 70mm
Max log diameter 350mm
Tank capacity 4.5L
Splitting force 10T
Engine power output 4.8KW
Total height(raised ram) 1535mm
Total height(retracted ram) 1055mm
Width 400mm
Length 845mm
Weight 125/135KGS
The actual splitting force may vary ±10%of the nominal rating
6.1Noise emissions
Noise emissions were measured in accordance with the European directives for the measurement of noise
Missions on the work place .The measurement was performed by external authorized certification bodies in
Compliance with the applicable standards based on applicable rules for agricultural and forestry equipment Noise
Levels were detected and measured at 1600mmheight both in front of the and 1000mmfar from it ,The detected
Noise level was
LpA=75dB(A)