KING DISH Tailgater Pro VQ4900, Owner'S Manual

Page: 7 / 32

Page 5
The DISH Tailgater Pro requires an unobstructed view of the southern sky for signal reception . Be
sure to place the DISH Tailgater Pro in a location free from obstructions such as trees, buildings, etc .
(See page 3 .) Point the handle approximately north to speed up scan time .
1 . Connect one end of the supplied RG-6 coax cable to the MAIN port on the DISH Tailgater Pro
and place in position . It is recommended you use only the supplied RG-6 coax cable .
2 . Connect other end of the supplied RG-6 coax cable to the SATELLITE IN port on your receiver .
DISH TAILGATER PRO SETUP
• Do not put the DISH Tailgater Pro where it can be bumped, knocked over or struck by a person or vehicle.
• Do not put the DISH Tailgater Pro near any heat sources.
• Do not route coax cable where it can be tripped on or run over by a vehicle.
• Do not overtighten coax cable connections.
• Do not put sharp bends or kinks in coax cable.
NOTE: Place the DISH Tailgater Pro on a stable and reasonably level surface with a clear view of the southern sky .
When placing the DISH Tailgater Pro in position, be sure surface is dry and free of loose dirt or sand .
HANDTIGHTEN COAX. OVERTIGHTENING CAN DAMAGE CONNECTIONS.
3 . Plug your receiver into a 110 volt AC power source .
• The green power light on your receiver should illuminate or begin cycling on and off .
• Wait for the green light to turn solid .
This may take up to two minutes .
• If it does not turn solid, power on your receiver using
the front panel POWER button . (On ViP211z
models, this is located behind the door panel .)
4 . Plug in and turn on your TV .
In your TV’s input selection menu, choose the input that matches the connection from your
receiver . (Example: If using an HDMI cable from your receiver, choose the HDMI input on your
TV .) See your TV’s Owners Manual for details .
Back of Wally Receiver
Front of Wally Receiver