CYCLER
Metered Pool Purifier
New
Water
400 SERIES
USE ONLY CYCLER PAC 400 SERIES
Replacing a
chamber
Cut handle from chamber using cutting tool or hacksaw
(KEEP OUT OF REACH OF CHILDREN)
B.
If using a chamber Cutting
Tool, place curved section of
tool around the narrow end of
one chamber tower and line up
blade on indent.
A. Find the
indent in
the plastic.
C.
Squeeze the handles
together. Repeat for other
side.
D.
If using a hacksaw to cut
the chamber, line up hacksaw
blade on indent and cut with
a smooth sawing action.
F.
If openings are pinched
together, open with fingers or
re-cut closer to the colored
screens inside chamber.
Leave at least 1/4" of plastic
to fit into Sparco Cycler base.
Finished cut ends
E.
Whether using a
chamber Cutting Tool or a
hacksaw, make sure the
blade comes straight across
on the indent line for a clean
chamber
towers
chamber
towers
Key in
Sparco
Cycler
Opening
in
chamber
A correct
oval opening
Avoid a
pinched
opening.
Indent in plastic
5
MIN
Replace cap by hand only.
DO NOT OVERTIGHTEN.
DO NOT USE CAP TOOL
TO TIGHTEN CAP.
FOR REMOVAL ONLY.
Turn off pump. Turn dial to
Minimum. This reduces the flow
of water into the unit when the
cap is open so isolation valves
are unnecessary.
Turn chamber over and
shake slightly until tablets
fall into tower areas.
Avoid sparks, open flame
or smoking when handling
the chamber.
Insert chamber into
Sparco Cycler, lining up
the openings in chamber
with keys in Sparco
Cycler.
The chamber is made of
HDPE plastic. When the
chamber is empty, triple
rinse in pool water, drain,
and recycle or wrap in
newspaper and discard in
trash.
CAUTION Read Carefully
–
USE ONLY
the factory recommended replacement chamber.
(See label.) DO NOT USE any other chamber or bulk chemical tablets in the Sparco Cycler.
Use of any other product could result in over chlorination, bleached liners, unsafe pool conditions,
fire or explosion. Warranty will be void if the correct chamber is not used.
Use the cap tool included with Sparco Cycler
to loosen cap by hitting the handle with the
flat of your hand counter clockwise. Stand
back upon removing cap to avoid inhaling
fumes.
1.
2.
4.
5.
7.
6.
3.
NOTE: Openings are a
different shape than keys.
