Page 15 of 17 King Pigeon Hi-Tech. Co., Ltd. Page 15 of 17 Ver 1.1 File No.:KPA1010
A Professional GSM Alarm System designer and manufacturer!
GSM SMS Controller System &GSM House Alarm System&
GSM Elderly Guarder & GPRS Telemetry Data Logger.
Http://www.GSMalarmsystem.com
2) When the AC power goes off, the transmitter of the wireless strobe siren will stop to transmit wireless signal to the
wireless strobe siren, so the wireless strobe siren will not work.
7.5 Remove wireless accessories.
After learned the wireless accessories to the Control Panel, it can be replaced by learning a new
wireless detector to its position to in stand of it. If you want to remove the wireless detector in specified
position, then please reset to remove all wireless detectors and re-learn the other wireless detectors
again.
8. Reset to Factory Default
The control panel can be reset to the factory default by following operation: Switch off the Control Panel, then
press the Reset Button (S1, nearby the SIMCard Socket), Switch on the Control Panel, about 3Seconds later,
the control panel will make “Di Di Di” 3 sounds, then loose the reset button, means the reset operation
successful.
After this operation, all the added wireless detectors and wireless panic buttons will be removed from the
control panel, and all of the settings will be reset to the factory default.
9. Installation
Before installing the Control Panel and detectors and sirens, please help to test the system firstly, including
power supply, gsm signal, etc.
9.1 Insert SIMcard into Control Panel
In the backside of the Control Panel, please install the GSM SIM card
. The GSM ANT must be
Vertical installation to ensure it in good working condition if you use the external GSM ANT. the Control Panel
cannot support external GSM ANT and internal GSM ANT at the same, so according to your condition to
choose one. The external GSM ANT with big gain so that is better when the GSM Signal is not good. In the
cover, we remain the external hole for the user to use external GSM Antenna, please ask the engineer to
change it if you need it. The hole is at the corner and very easy to remove the shutter.
