Page 12 of 17 King Pigeon Hi-Tech. Co., Ltd. Page 12 of 17 Ver 1.1 File No.:KPA1010
A Professional GSM Alarm System designer and manufacturer!
GSM SMS Controller System &GSM House Alarm System&
GSM Elderly Guarder & GPRS Telemetry Data Logger.
Http://www.GSMalarmsystem.com
and panic buttons to it easily following the below instructions.
Remove the SIMCard cover, see below figure, then press the Learn button, switch on the Control Panel,
after 3Seconds, the unit will alert long “Di” sound to indicate it being learning mode.
Notice:
1) The Control Panel cannot exit the learning mode automatically, must switch off the unit then switch on again to enter the
normally mode.
2) The Control Panel with fixed position for different wireless detectors, the positions please see below table.
3) The positions must be active to learning mode by switch the button from OFF to ON, and after learned the correct detector
into this position, please switch the button back to OFF, otherwise the position will in learning mode all the time.
4) When learning one detector to the control panel, the other switches must be in OFF position.
Zones’ Attribute
Numbers on Switch
Positions
Watchdog
Switch1-4
24-Hour Zone
Switch5-7
Panic Button
Switch8-10
7.1 Add the Wireless PIR Motion Detector to Watchdog zones of the Control Panel.
When the Control Panel in the learning mode, then switch the
Switch1
from OFF to ON, and trigger the PIR
Motion Detector by pass though it, the Control Panel will learn the code from the wireless PIR Motion Detector
automatically. When alert by long “Di----” sounds, means the wireless PIR Motion Detector was learned to the
A0 Position,
please switch the switch back to OFF.
If alert by “Di Di” two sounds, then means the operation
failure, please switch it back to OFF then retry again.
Switch the Switch2, Switch3, and Switch4 from OFF to ON one by one to learn the 2nd, and 3rd, 4th Wireless
PIR Motion Detectors to the Control Panel.
Notice:
When the wireless PIR Motion detection is PIR-100B, please remember setup the PIR-100B to Test Mode while learning to the
Control Panel, after learned to the Control Panel, then please setup to Normal Mode by change the Black PIN Jumpers in the
PCB, please see the PIR-100B user manual.
When the wireless PIR Motion Detector is PIR-100A, or CPIR-100A, or CPIR-100B, please refer to 7.2 Notice. The differences of
