ADJUSTMENTS & OPERATION
FAST DOWNFEED & MICRO DOWNFEED CONTROLS
This Mini Milling/Drilling Machine comes with two methods of downfeed, fast and
micro. Fast feed method is normally used for drilling operations, and the micro
feed method is normally used for milling operations.
1. Before making any adjustments or using the downfeed handles, loosen head
lock lock handle (A) Fig.8.
2. For fast feed method, simply grab one of the downfeed handles (B) Fig.8 and
turn it to raise or lower the head quickly.
3. For micro feed method, push in the downfeed handle hub (A) Fig.9 towards the
head until the teeth (B) engage the hub teeth. Once the teeth are engaged,
the micro feed handwheel (C) can then be turned to set the desired depth.
MILLING TAbLE TRAVEL
This Mini Milling/Drilling Machine comes with a milling table which can be moved
on the X-axis (transversal travel) and Y-axis (longitudinal travel). The milling table
is controlled by the front and side handwheels.
1. Before making any X-axis (transversal travel) adjustments to the milling table,
loosen X-axis lock handle (A) Fig.10.
2. To adjust the position of the milling table in the X-axis (transversal travel), turn
front handwheel (B) Fig.10.
3. Before making any Y-axis (longitudinal travel) adjustments to the milling table,
loosen Y-axis lock handle (C) Fig.10.
4. To adjust the position of the milling table in the Y-axis (longitudinal travel), turn
side handwheel (D) Fig.10.
TILTING HEAD/COLUMN
This Mini Milling/Drilling Machine comes with head/column assembly which can
be tilted up to 45
0
to the right or left.
WARNING!
This Mini Milling/Drilling Machine must be bolted to a workbench or
a stand before attempting to tilt the head/column assembly. If this warning is not
respected, machine will tip over and cause possible damage to machine.
1. With one hand hold the head/column assembly, with your other hand, loosen
the large hex. nut (A) Fig.11 using the large 36mm wrench (B).
2. Position the head/column assembly in the desired angle, using the angle scale
in front of the column as a guide. Once positioned in the desired angle,
retighten the large hex. nut (A).
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
