ASSEMbLY & TEST RUN
UNPACKING, CLEANING AND MOUNTING TO WORKbENCH OR STAND
Remove all contents from the packing. Lift the Mini Milling/Drilling Machine using
handling equipment or get the help of an assistant and place it on level
workbench or stand. Make sure the workbench or the stand is sturdy enough to
support the weight of this Mini Milling/Drilling Machine (110 lbs). Secure the base
to the workbench or stand using the 4 mounting holes (A) Fig.4 and hex.
bolts/nuts (hardware not included).
The unpainted surfaces of the Mini Milling/Drilling Machine are coated with a rust
preventive oil which needs to be removed before starting assembly. Use a
solvent cleaner that will not damage painted surfaces.
INSTALLING HANDWHEEL HANDLES
1. The adjustment handwheels (A & B) Fig.5 come installed to the machine. The
handwheel handles (C & D) Fig.5 must be installed.
2. Screw in handle bolt with a flat screwdriver.
TEST RUN
Once the Mini Milling/Drilling Machine is secured to workbench or stand and
handwheel handles are installed, it is necessary to do a test run to make sure
everything is working as intended:
WARNING!
Do not change the speed range (Low/High speed range lever) while
the machine is running! If warning is not respected you risk damaging the
spindle.
1. Make sure all tools and accessories have been removed from the machine.
2. Connect the power cord to an appropriate 120V wall outlet. The power
indicator light (A) Fig.7 will light up.
3. Place the Low/High speed range lever (A) Fig.6 in the Low position (towards
the left) as shown.
4. Turn the On/Variable Speed dial (B) Fig.7 clockwise to start the machine. Let
the machine run at low speed for approximately 10 minutes. Make sure the
machine is running smoothly without any excessive noises or vibration. If you
hear any unusual noises or if the machine vibrates excessively, shut the
machine off immediately. This can be done by turning the On/Variable Speed
dial completely counterclockwise or press the emergency button (C).
5. Increase the speed, let the machine run for another 10 minutes.
6. Increase the speed once again, let the machine run for another 10 minutes.
7. Stop the machine by pressing the emergency stop button. Reset the On/Vari-
able Speed dial by turning it counterclockwise to the off position.
8. Shift the Low/High speed range lever (A) Fig.6 in the High position (towards
the right). Repeat steps 4-7.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
