FIGURE 6
ASSEMBLY
FIGURE 7
FIGURE 8
BASE, COLUMN & TABLE ASSEMBLY
1) Position the base (A) Fig.6 on the floor. Remove the protective
covering and discard.
2) Remove protective bag from the column, column support and table
support assembly (B) and discard. Place the column assembly on the
base, align the holes in the column support with the holes in the base.
3) Locate four long hex. bolts from the parts bag.
4) Install a hex. bolt (C) Fig.6 in each hole through the column support
and the base and tighten with a wrench.
Note: It is recommended to securely fasten the drill press base (A) Fig.6
to a wooden base or floor. This would prevent the drill press from
possibly tipping over, walking during operation.
5) Locate the crank handle (A) Fig.7 and install it on the worm gear shaft
on the side of the table support (B). Tighten the set screw (C) on the
flat section of the worm gear shaft.
6) Install the table support lock handle (D) Fig.7 to the table support as
shown.
7) Install the table lock handle (A) Fig.8 to the table support as shown.
Do not tighten.
8) Slide the table (B) Fig.8 into the opening of the table support. Tighten
table lock handle (A).
