8” JOINTER ASSEMBLY
ASSEMBLING CUTTERHEAD PULLEY GUARD / CARRIAGE
MOUNTING BRACKET
1. Align two pins (A) Fig. 7, in mounting bracket (C) with two holes (B)
at the rear of jointer (D).
2. Using the supplied hex. key (E), fasten mounting bracket (C) Fig. 8, to
the jointer with four M8 x 55mm long hex socket head screws, lock
washers, and flat washers (F), three of which are shown.
ASSEMBLING FENCE CARRIAGE ASSEMBLY
1. Fasten fence carriage assembly (A) Fig. 9, to cutterhead pulley
guard/carriage mounting bracket (B) using two M8 x 20mm long hex
socket head screws, lock washers, and flat washers (C) through holes
in fence carriage assembly, one of which is shown at (D).
2. Fig. 10 illustrates the fence carriage assembly (A) properly mounted to
the jointer.
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
