Kinderkraft ONETO3, User Manual

Page: 34 / 120

34
• Loosen the harness by pressing the positioning button (F) and pull the harness straps
straight out as far as possible.
• Press the lever (L) in the top part of the headrest and raise the headrest to the highest
position. Unlock the buckle and place the shoulder straps of the harness on the sides of the
booster seat. Run the buckle (D) through its cushion (E) and the slit in the base cover. Unlock
the cover fasteners on the booster seat’s backrest to reveal plastic elements.
• Open the compartment on the bottom of the booster seat base (under the cover). Lock in
the harness buckle (D) and hide it in the compartment.
• Close the compartment. Run the shoulder straps back through the guides in the plastic
element of the booster seat’s backrest .
6.2 Removing the cover
• Hide the harness and remove the insert – if installed (see point 6.1). Raise the headrest to
the highest position. Carefully remove the cover starting from one side. Release the fasteners
on the main cover element and remove them.
6.3 Installing the cover
• Adjust the cover appropriately to the fixing points of the chair, put the cover on around the
positioning button (F), and stretch it out on the seat and backrest.
• Put the shoulder pads (I) on the harness straps.
• Open the compartment in the back of the booster seat (S). Slide the straps of the shoulder
pads through the slits in the backrest (A) and put on the metal bar.
Make sure that the harness straps are not twisted.
6.4 Cleaning
Use only the genuine cover, which constitutes an important element of the booster seat’s
safety.
ATTENTION: Never use the booster seat without the cover.
• You can remove the cover and machine wash it in mild detergent at a low setting (30°C).
Always obey the washing directions on the cover’s tag. Washing in temperature exceeding
30°C may cause the colours to fade. The cover should
not be spin-dried in a drum dryer (which
may lead to the material delaminating).
• You can clean plastic elements with soapy water. Do not use aggressive cleaning agents (like
solvents).
• You can clean the harness in warm water with soap.
Attention! Never remove the metal fasteners from the straps.
7. Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period
starts from the date the product is handed over to the Buyer.
2. The warranty is only valid in the member states of the European Union, excluding
overseas territories (as currently defined, including in particular: Azores, Madeira,
Canary Islands, French Overseas Departments, Åland Islands, Athos, Ceuta, Melilla,
Helgol and, Büsingen am Hochrhein, Campione d'Italia and Livigno) and the territory of