3.7
LIGHTING THE FIRE - REMOTE CONTROL MODELS
3.7.1
Ensure valve power isolation switch is in the on position - see figure 27
Hold the handset with one hand ensuring your hand is wrapped
around the back and that your hand is in contact with both sides of the
handset. The green light of the “unlock” symbol should light.
See figure 29 below.
3.7.2
Press and hold the power button continuously until the red light
illuminates next to the operation symbol (this typically takes two
seconds). As the red light illuminates release immediately the power
button. The red light will the flash as the burner is being lit. While the
burner is lighting the red light will flash. When the burner has lit the red
light will stop completely. The burner will now be lit at maximum heat
input level.
NOTE : If the power button is pressed for too long or two short a time or
the grip on the handset is not firm or is released too soon, the lighting
sequence will be interrupted and not complete. The reason for the
remote control having this strict start sequence is for safety reasons
so that the starting operation of the fire will be most unlikely to be
done other than intentionally by an adult.
Fig. 29
31
Power button
Unlock symbol
(illuminates green)
Operation symbol
(illuminates red)
+ button (increases
heat input level)
- button (decreases
heat input level)
