9
50L WET & DRY WORKSHOP VAC
9) Troubleshooting
PROBLEM
CAUSES
SOLUTIONS
The Vacuum Cleaner fails
to start
Power cord is disconnected
Check the electric power
supply cord is connected to your wall
socket correctly
Vacuum is not switched ON
Check that the vacuum is turned on. To
turn on the vacuum press the ON/OFF
switch (18) to the “ON” “I” position.
Electrical fault
Contact Kincrome Customer Service.
On / Off Switch (18) switched to
“PTO ON” “II”
Vacuum will not operate unless a power
tool is connected to the PTO outlet (17) and
the power tool is switched ON.
Check that the vacuum switch (18) is
turned ON. To turn ON the vacuum press
ON/OFF switch (18) to the “ON” “I” position.
Substantial increase in motor
revolutions and decrease in
suction
Vacuum hose (2) blocked
Ensure that the vacuum hose (2) is not
blocked by removing the hose assembly
and inserting a broom handle through the
hose to clear any obstructions. Do not use
excessive force to clear obstructions.
The vacuum safety float valve (19)
cuts off the vacuum.
A. This can happen when the
vacuum tank (14) is full of liquid
B. The vacuum has overturned.
A. Turn off the vacuum and empty the
vacuum tank (14).
B. Upright the vacuum and turn it off for
approx. 3-5 seconds
Summary of Contents for KP704
Page 12: ...www kincrome com au...
