12
SMD LED WORKLIGHTS
OPERATION
Note:
Always ensure that the LED worklight is directed away from you or other bystanders before switching the
LED worklight ON. The LED light output could cause damage to the eyes if directed at a bystander’s eyes.
Adjusting the LED Light Output Direction Up/Down
1.
The LED work light heads can be tilted 30° downwards or 90° upwards.
2.
To tilt the LED worklight up or down, loosen the tilt lock knobs (2) (Fig 21) in an anti-clockwise direction and tilt the
worklight into the desired direction (Fig 22) and then re-tighten the tilt lock knobs (2) by rotating clockwise (Fig 23).
(Fig 21) (Fig 22)
(Fig 23)
Adjusting the LED Light Output Direction Left/Right
1.
The LED work light heads can be rotated 180° to the Left or Right (Fig 24).
Caution:
Becareful not to stretch or twist the worklights power cable.
2.
To rotate the LED worklights Left or Right, loosen the light lock knob (5) by rotating anti-clockwise (Fig 25) and rotate the
worklight into the desired direction (Fig 24).
3.
Secure the worklight into your desired direction by rotating the light lock knob (5) clockwise until tight (Fig 26).
(Fig 24) (Fig 25)
(Fig 26)
Adjusting the Height of the Telescopic Stand Up/Down (Models KP2303, KP2304 & KP2305)
1.
The LED work light can be raised or lowered to the desired height.
The Telescopic Stand (5) has a dual stage height adjustments.
2.
To adjust the height of the upper section of the telescopic stand (5), loosen the upper telescopic lock nut (5a), by rotating
anti-clockwise (Fig 27) and raise the telescopic stand to the desired direction (Fig 28), then secure the by rotating the
telescopic lock nuts (5a) clockwise until tight (Fig 29).
3.
To adjust the height of the lower section of the telescopic stand (5), loosen the lower telescopic lock nut (5a), by rotating
anti-clockwise and raise the telescopic stand to the desired direction (Fig 28), then secure the by rotating the telescopic
lock nuts (5a) clockwise until tight (Fig 29).
(Fig 27) (Fig 28) (Fig 29)
Turning ON/OFF the LED Worklights
1.
To turn ON the LED Worklight, plug in the power cord to your mains power socket and turn the mains outlet switch ON.
2.
To turn OFF the LED Worklight, turn the mains outlet switch OFF.
Summary of Contents for KP2301
Page 14: ...www kincrome com au...
