7
PRESSURE WASHER 1520PSI
Attaching/Detatching the Quick Connect Gun to the High Pressure Hose
1.
With your quick connect gun (10), extension lance (11) and lance (12) fully assembled, attach the high pressure hose (9).
2.
Locate the male end of the high pressure hose (9) and align it to the quick connect gun (10) inlet port, as shown (Fig 14).
3.
Push the high pressure hose (9) end into the input port of the quick connect gun (10), until you hear it click into position (Fig 15).
4.
To remove the high pressure hose, push in the blue button located on the side of the quick connect gun (10) above the inlet port,
to remove the high pressure hose (9) from the quick connect gun (10).
Attaching/Detaching the Detergent Dispenser to the Lance
1.
Push the blue quick release button located on the top of the installed nozzle (13 or 14) and pull the nozzle off the lance (12).
2.
To fit the detergent dispenser (15) push in the blue quick release button located on the side of the detergent dispenser (15) and
feed it onto the lance (12) (Fig 16). Your detergent dispenser (15) is now ready to use (Fig 17)!.
3.
To detach the detergent dispenser (15), repeat step 1.
Attaching/Detaching an Inlet Hose to Your Pressure Washer and Mains Water Tap
Note:
This Pressure Washer, doesnt come supplied with an inlet hose, you must purchase one at your own expense from your local
hardware store. Depending on the hose purchased, you will also need to purchase an inlet coupler and an additional inlet hose
adaptor. The hose should be a reinforced wall hose, to ensure the hose does’nt collapse, when the Pressure Washer is being
used. It is recommended that the minimum inside diameter of this hose should be no less than 13mm (1/2”).
1.
Once you have your inlet hose, you must connect a male hose adaptor to your mains water tap or storage device. Make sure you
have screwed the male hose adaptor securely (Fig 18).
2.
Once installed, you must fit a female inlet coupler (not supplied) to either end of your inlet hose. Ensure they are firmly secured
to your inlet hose (Fig 19).
Note:
Some hoses have adaptors preinstalled when purchased.
3.
Grab one end of your hose, and pull back the female inlet coupler and feed onto the male inlet adaptor located on your mains
water tap. They should click into position (Fig 20).
4.
With the free end of your hose, feed the remaining female inlet coupler onto the hose adaptor (16) installed previously, located
on the rear of the Pressure Washer (Fig 21).
5.
Your Pressure Washer is now ready to receive water!
6.
To Remove the inlet hose, repeat the above in reverse.
(Fig 16)
(Fig 17)
1
2
(Fig 18)
(Fig 20)
(Fig 21)
(Fig 19)
(Fig 14)
(Fig 15)
