9
PRESSURE WASHER 1520PSI
Pressure Washer Draw from Bucket or Water Storage Device (Continued)
Note:
The hose required for this feature can be purchased from any hardware or hose supplier. Depending on the hose purchased,
you will also need to purchase an inlet connector, which can be attached to the hose adaptor (16).
This hose should be a reinforced wall hose, to ensure the hose does not collapse, when the Pressure Washer is being used.
It is recommended that the minimum inside diameter of this hose should not be less than 13mm (1/2”) but a 19mm (3/4“) hose is
recommended to provide sufficent water supply to the Pressure Washer.
Note:
The maximum height between the water inlet connector (8) and surface of your water supply must be no more than 0.5 m;
above this height, the Pressure Washer will not achieve suction correctly.
Note:
If water does not flow out of the Pressure Washer within two minutes , turn the unit OFF and check all connections. Loose
connections will not allow the product to operate correctly.
Note:
For self-priming function, connect the suction hose (not included) to the Pressure Washers inlet connection only using the hose
adaptor (16) included.
1.
Remove any nozzles (13, 14,15) from the lance (12) connector (Fig 30).
2.
Submerse your inlet hose (not supplied) in the water source to fill the hose with water (Fig 31).
3.
While keeping the inlet end of the suction hose submerged in the water storage device, connect the output end of the suction
hose directly onto the hose adaptor (16) which has been installed on the water inlet connector (Fig 32).
4.
Turn the ON/OFF switch (3) ON (I) position and hold down the trigger on the quick connect gun (10).
5.
Wait until the water comes out of the lance (12) and turn the Pressure Washer OFF (O).
Note:
Allow water to flow for 20-30 seconds to purge any air bubbles.
6.
6. Re-install a pressure nozzle (13, 14, 15) to the lance (12) (Fig 33) and you’re now ready to clean!.
Trouble Shooting
(Fig 30)
(Fig 31)
(Fig 32)
(Fig 33)
1
2
1
2
