kincrome K16003, Owner'S Manual

Page: 11 / 25

Installation—K16005
11
Step One: Disconnect pump from power supply
Step Two: Disconnect inlet and outlet fittings from pump

Remove steel clips from inlet and outlet ports of the pump.
 Pull inlet and outlet fittings out of the pump. Do not disconnect hoses from
fittings.
Step Three: Remove pump from sprayer
 Remove four screws from pump mounting feet.

Remove pump from sprayer.
Step Four: Assemble fittings to regulator
 Remove steel clips from outlet
and bypass ports of regulator.
 Install QC x 3/8" HB fitting
into bypass port of
regulator. To insert quick connect
fittings, lubricate O-ring with
water and twist fitting while
inserting into pump port. Secure
with steel clip.
 Thread pressure gauge into 1/4"
NPT port on front side of
regulator (the side of the
regulator with the “BYPASS”
label).

Thread 1/4" NPT plug
into 1/4" NPT port on back side
of regulator.
 Install QC x 3/8" HB, elbow
into outlet port of
regulator. To insert quick connect
fittings, lubricate O-ring with
water and twist fitting while
inserting into pump port. Secure
with steel clip.
Step Five: Assemble regulator and fittings to pump
 Install inlet port of the regulator into outlet port of the pump. Secure with steel
clip.

Turn regulator to orient knob toward the top of the pump.
Step Six: Drill hole in tank
 Align the four circles on the supplied drill template sheet with the pump mounting
holes on the sprayer tank.
 Using a 9/16" drill bit (not included) drill a hole through the top of the tank in the
position indicated by the appropriate X on the template.
 Remove plastic debris from inside the tank (if chemicals have been used inside
the tank, refer to pg. 18 step 4 for personal decontamination after removing
debris).