kincrome K16003, Owner'S Manual

Page: 10 / 25

Unpacking and Sprayer Identification
10
Identify your sprayer
 Your sprayer model number can be found on the serial number decal located on the pump.
If you cannot locate the model number on your serial number decal, refer to the table below
to determine the model number of your sprayer. Turn to the assembly section for your
sprayer on the page number listed in the table.
Sprayer
Model
Tank size
Pump model
Defining features
K16005 38 Litre K16102 Spot spray gun only
K16006 60 Litre K16103 Spot spray gun and single-nozzle broadcast lance
K16007 98 Litre K16103 Spot spray gun and single-nozzle broadcast lance
NOTE: Kincrome does not recommend the use of metal fittings or rigid pipe to plumb the inlet/outlet
ports. Standard plastic threaded fittings are available by calling Kincrome Customer Service at
1300 657 528.
 In some cases, fittings may require a suitable thread sealer applied sparingly. DO NOT
over-tighten; maximum torque is 45 in.-lb [5 N-m].
 Tubing should be compatible with the spraying fluid. At least 18
"
[450mm] length is
suggested to minimize stress on the fitting/ports and reduce noise. Allow for the shortest
possible tubing route and avoid sharp bends that may kink over time.
 Installation of a 50-mesh strainer is recommended to prevent foreign debris from entering
the system. Failures due to foreign debris are not covered under the warranty.
NOTE: Restrictions on the inlet may cause a loss in performance. Inlet pressure must not exceed 30
psi [2.1 bar]
 If a check valve is installed in the plumbing, it must have a cracking pressure of no more
than 2 psi [0.14 bar].
CAUTION
Sealers and Teflon tape may act as lubricant causing cracked housings or stripped threads due to
over tightening. Care should be used when applying sealers; it may enter the pump inhibiting
valve action, causing no prime or no shut-off. Failures due to foreign debris are not covered
under the warranty.