5
1/2” DRIVE AIR IMPACT WRENCH
9) Cleaning, Maintenance, and Lubrication
Note:
These procedures are in addition to the regular checks and maintenance explained as part of the regular operation of the
air-operated tool.
The air motor and bearing uses compressed air to power the tool. Moisture in compressed air will rust the motor components, you
must lubricate the motor with Kincrome Air Tool Oil daily.
Lubrication
1.
Disconnect the tool from the air supply holding it so the air inlet (5) faces up.
2.
Hold the trigger (2) down and put 4 to 5 drops of Kincrome air tool oil in the air inlet. Holding the trigger down helps circulate oil
in the motor.
3.
Connect the tool to air supply, cover the exhaust (1) with a towel and run for a few seconds.
WARNING!
Any excess oil in the motor is immediately expelled from the exhaust (1) .Always direct exhaust (1) away from
people or objects.
Storage
4.
Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool and run it for a short time.
5.
Regular inspection should be carried out of spindles, threads, and clamping devices inrespect of wear and for location of
abrasive products.
10) Warranty
Warranty given by Kincrome Australia Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria (Tel 1300 657 528).
The applicable warranty period (24 months) commences on the date that the product is purchased. If this product has materials or
workmanship defects (other than defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of
purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement. Your rights under this warranty
are in addition to any other rights you have under the Australian Consumer Law or other applicable laws. Our goods come with guaran
-
tees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a major failure. For further details please visit www.kincrome.
com.au or call us. Due to minor changes in design or manufacture, the product you purchase may sometimes differ from the one shown
on the packaging.
IMPORTANT! If the tool fails to operate correctly, call customer service on 1800 657 528 for advice on the best resolution for your situa
-
tion. If a resolution cannot be achieved over the phone please take the tool and all related accessories to an authorised service centre or
place of purchase showing proof of purchase for assistance.
Summary of Contents for K13204
Page 8: ...www kincrome com au...
