IMPORTANT SAFETY INFORMATION
The use of an engine stand has inherent dangers to avoid risk of personal injury or property damage make
sure you are fully aware of the operating instructions for this product. Do not exceed the working load limit
of this engine stand. This engine stand is intended for automotive use only. Be aware that large or heavy
engines may exceed stands stated capacity check vehicle owners manual or contact the engine manufacturer.
Do not use for any other purpose accept to support an engine during maintenance.
UNPACKING AND ASSEMBLING STAND
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove components and lay them out neatly on
selected work surface. Make sure all nuts, bolts, washers, and pins, are properly identified and placed
safely until needed
Assembling Engine Stand
Step 1
Insert center bar into main up right,
position rear wheel par and secure all
three using bolt #10, washer #8 lock
washer #7 and nut #6
Step 2
Attach front wheel bar using bolt #9,
washer #8 lock washer #7 and nut #6.
Step 3
Attach front castor wheels #13 using
washer #8 lock washer #7 and nut #6
Step 4
Position wheels 12 on the rear shaft
hold in place with washer #2 and
retaining ring #11
Step 5
Attach engine mounts to face plate hold loosely with bolt #1, washer #2, Lock washer #3, and nut #4. Place
assembled face plate into stand upright and hold in place with pin #5
Step 6
Recheck all nuts and bolts are tight and that stand is stable when placed on a flat level surface
