2
VEHICLE MOUNTING
WARNING
:
Contact your local State and Territory Registration Authorities for regulations and requirements regarding the fitment of LED light Bars.
Constraints remain on the fitment of LED light bars, so any LED light bar that is fitted must be installed in alignment with the following requirements
(also contact your local RTA authority)
:
Before beginning, take some time to determine how and where you will fit the light bar to your vehicle.
1.
The lamps should, as far as is possible, be installed symmetrically in pairs to the front of the vehicle.
2.
If lamps are not fitted as pairs (e.g. one, three etc), they must be fitted to the front of the vehicle and as close as possible to the centre of the vehicle.
3.
A maximum of four driving lamps (including LED light bars) can be fitted to a vehicle in addition to the vehicle’s main beam headlamps.
4.
The lamp/s must be installed in a way that the light produced does not cause the driver of the vehicle discomfort either directly or by reflection.
5.
The lamp/s must only come on when the main-beam (high beam) headlamps are used, and must automatically turn off when the main-beam headlamps
are turned off.
6.
The lamps must not obstruct the driver’s view of the road.
7.
Cannot be used to dazzle other road users.
WIRING INSTRUCTIONS
LED Light Bars must be wired in such a way that they only switch on with the main
beam (high beam) head light.
It is recommended you purchase a pre-made wiring kit from an automotive store.
Caution:
When creating your own wiring loom/harness, ensure that adequate sized
wiring for the distance of the cable run is used. Failure to use correct sized wiring
for the current draw and voltage drop may result in damage to the light bar through
overheating or fire.
WARRANTY
Warranty given by Kincrome Australia Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria (Tel 1300 657 528). The applicable warranty period (12
months) commences on the date that the product is purchased. If this product has materials or workmanship defects (other than defects caused by abnormal
or non warranted use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes addresses for
repair or replacement. Your rights under this warranty are in addition to any other rights you have under the Australian Consumer Law or other applicable
laws.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure. For further details please visit www.kincrome.com.au or call us. Due to minor changes in
design or manufacture, the product you purchase may sometimes differ from the one shown on the packaging.
WHAT IS NOT COVERED
This warranty does not cover fading or discoloration caused by exposure to sunlight or chemicals such as ammonia, household bleach, or any cleaning
material that contains abrasive substances.
Kincrome does not cover the cost for removal and/or reinstallation of any kind including any damaged cause during or after fitment to vehicle. This warranty
is void and inapplicable if Kincrome deems that the product was abused or misused; including but not limited to damage caused by accident, mishandling,
improper installation, negligence, normal wear and tear, excessive water or heat damage, freight damage or products that have been altered in any way.
The warranty is not transferable and will not apply to products purchased from unauthorized dealers.
Kincrome is not responsible for any damages to a consumer’s vehicle or person from a product failure.
The warranty is void if it is deemed the product was installed or used improperly.
+
+
Switch
Fuse
High beams
Ground/earth
Ground/earth
Ground/earth
Typical
4 Pin Relay
40A
LED LIGHT BAR
3W CREE
