HALP-96-2L-LED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
1
Hazardous Location Corrosion Resistant LED Light Fixture
Instruction Manual
Thank you for your purchase of the Larson Electronics HALP-96-2L-LED Corrosion Resistant light fixture.
Please follow the steps below in order to operate and maintain this product.
FIXTURE ASSEMBLY
Fixtures are shipped separately for shipping purposes and must be re-assembled for operation.
1.
Remove fixtures from their packaging.
2.
Place fixtures side by side with the wire side of one facing the open end of the opposite light fixture. There
will only be one fixture with excess wiring tucked into it and one fixture with an open end.
3.
Un-tuck wiring from first fixture along with lock nut and insert wiring into the other light fixture.
4.
Open the second fixture (with open end) to access its internals. See
page 2
steps 3 thru 5 to open and
release the lamp tray from the light fixture.
5.
Once open, place the first fixture
’s threaded conduit through the open end of the second fixture.
6.
Slide the lock nut through the wiring before connecting to wire terminal.
7.
Tighten lock nut down over conduit to secure the fixtures together.
8.
Connect the wires from the first light fixture to the wiring terminal. Match the colors to the wires already
there. White to white, black to black.
9.
Once the wiring has been connected, close the lamp and proceed to mounting.
FIXTURE 1
FIXTURE 2
