Kinco 3M2280N, User Manual

Page: 29 / 34

3M2280N Step Motor Driver
11
3.5 DIP Switch Settings
The driver is configured with two round DIP switches S1 and S2, which are used for
micro-step value selection, current value selection and functions selection.
S1, Micro-step:
S1 0 1 2 3 4 5 6 7
Pulse/rev 400 500 600 800 1000 1200 1500 2000
S1 8 9 A B C D E F
Pulse/rev 3000 4000 5000 6000 10000 20000 SET1 SET2
S2, Current:
S2 0 1 2 3 4 5 6 7
Peak(A) 2.80 3.20 3.60 4.00 4.40 4.80 5.20 5.60
Rms(A) 1.98 2.26 2.55 2.83 3.11 3.39 3.68 3.96
S2 8 9 A B C D E F
Peak(A) 6.00 6.40 6.80 7.20 7.60 8.00
M1 M2
Rms(A) 4.24 4.53 4.81 5.09 5.37 5.66
OPERATION TABLE:
MODE S1 S2 METHOD
Auto Run F 0~D Set the s1&s2 as S1=F,S2=0~D when driver is power
off, then power on the driver, the motor will run
automatically.
PLS+DIR E E Set S1 and S2 as the
“MODE settings ( as the left
table)
” when driver is power off, then power on the
driver, the 4 standards LED will run as: , this means
the mode setting is success, then reboot the driver,
the driver will work in setting mode.
CW/CCW E F
HALF
CURRENT
E C
FULL
CURRENT
E D
Precautions on rotary switch:
1.
S1 cannot be set to NA; otherwise, the driver will generate an alarm. In this case, turn
off the power, re-set the micro-step values, and turn on the power again to resume
normal.
2. To set the status of the DIP switch, choose an appropriate straight screwdriver; a
screwdriver of inappropriate size may cause damage to the DIP switch.
3. When setting the status of the DIP switch, do not apply an axial force; otherwise, it
may cause damage to the DIP switch.