FingerVein Online
Installation and Programming Manual
Page
63 of 69
Each of the previous values is written by means of the instruction:
. To make the new configuration effective, the instruction:
should be run.
A.1.3. KRD13Mv2 reader configuration
The KRD13Mv2 reader can be configured to automatically read block 1 of the Mifare
card, reducing the reading to 10 bytes and sending them through the serial port:
Table 14: Reader configuration example
Param.
number
Parameter name
Value
Details
$1B
CFG-UI_SerialPortReader
$BB
FingerVein, at 57600
baud
$1C
CFG-UI_PortSerialHost
$40
KRD13M, at 9600
baud
$08
CFG-UI_Reader_ Enable
$55
Readers enabled:
- UART2: prefix ‘$’
- TTL0: prefix ‘*’
$09
CFG-UI_Reader_ BuzOK
$05
Beeper for correct
card readings.
$0A
CFG-UI_Reader_ BuzError
$05
Beeper for wrong
card readings.
Table 15: KRD13Mv2 configuration example
Frame to send
Explanation
$0A060001000100091B
Read block 1, positions 0 to 9, with key
1 as Key A
$200701FFFFFFFFFFFF22
Write key 1 on EEPROM
($FFFFFFFFFFFF in the example)
$0406000564
02
0AFF7E
Configure byte 4 to automatic mode
$02
