Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-M-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
34
A. Due to different reasons that may happen such as:
•
If we can get the output (Terminal, software communication), the LED may have some technical issues.
•
The protected terminal is not working.
Please consult with your Reseller.
Q. How to troubleshoot the communication between the Module and PC?
A. If you face any communication difficulties between the Module and PC please troubleshoot as follows:
•
Double Check the cable connection (try to use anther USB cable).
•
Try to use anther port in the PC.
•
Check the Module USB drive in your PC from setting then search for Device Manager then go to ports as
shown below (Please refer to USB serial driver quick install).
After the troubleshooting if the problem still doesn’t solve, please
consult with your Reseller.
Q. The Module is showing Contact Service.
A. Contact your Reseller for customer support.
Q. How to update the Firmware.
A. New Firmware is uploaded to
https://www.amberandwaseem.com/
.Always check the website for an
update.
Q. The Module doesn’t seem to show correct State of Charge (SOC).
A. The Module is using the previous data to correct the state of charge in the long run. Charge the Module to
maximum Voltage and then discharge it to cut-off Voltage and repeat the process several times to correct the
SOC. Note that open voltage is not directly related to SOC.
Q. Can the Sirius Module be installed standing vertically with the connection facing up without potentially
stressing the cells inside the Module?
A. Yes, but NOT in a movable\vibrating position.
Q. What is the difference between the ‘’balancing “and “auto balancing” in “set Config” tab in SiriusVIEW?
A. Balancing: Balancing can be activated from any voltage level when the Module is in standby mode (Zero
current). When all the cells get balance, the balancing will stop. The time required to balance all cells depends
Figure:
Module Port
&com number
