Centauri Energy Server
–
User Manual
Model Number - GF-20000-360Vdc-380Vac-3/3
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
27
8. Connect
“
PV INPUT 1#
—
4# +
”
and
“PV
INPUT 1#
—
4# -
”
poles of the Energy Server to the
“
output
+” and “output
–”
poles of the corresponding PV combiner boxes of PV1 # - PV4#. Besides, the
electrode and the grounding terminal should not be shared among the different groups.
9. Insert one end of the temperature sensor of the battery pack freely supplied with the device into
BAT. TEMP, and the other end stretched into the Middle battery of the Battery Pack.
10. Confirm that all switches of the Energy Server are completely shut down and the external switches
of
“
rectifier power supply, the bypass power supply and the battery
pack”
are switched on, and then
use the multimeter to test and make sure that
the voltage and polarity of the system comply with the
relevant requirements of the system rated voltage.
11.
Install all protective cover plates in place.
4.11 Communication Interface:
Energy Server has RS485 and RS232 interface to communicate with Host PC for:
•
Measurement Monitoring
•
Alarm Monitoring
•
System Configuration
•
Measurement Calibration
•
Manual/Auto Data Logging\Module firmware updating
•
Internal SD card reading/refreshing
•
Statistical Analyzing/ Graphical result
•
The system is provided with the preset
“
SNMP
”
card port (SNMP card for option) to facilitate
the users to realize the remote monitoring (option).
4.12 Signal Interface:
•
The control signal input interface refers to the 2Pin interface, therefore the corresponding order
can be conducted when in short circuit, as shown in the following figure.
