────────────────────────────────────────────────────────
KILOTECH INC.
www.kilotech.com
10
6. Accumulation Mode:
Press ACC key to add current weight to accumulation memory, the accumulation time’s counter will
increase by 1 and display total accumulative weight.
7. Check Weight
Check weight in weighing mode:
7.1 To use the check weight function,
CONFIG-FUNC-COMPAR
item should set to
YES
, and high and low
limitation of weight should be set correctly according to following steps:
7.2 In weighing mode, Press down
DATA
key more than 3s to input compare data of high and low.
7.3 After
HIGH
being shown, 000000 will be displayed, use
,
ACC
,
UNIT
key to input high weight
number and press
TARE
key to confirm. Annunciator of
Hi
will be shown in this step or press
ZERO
key to
exit and back to weighing mode.
7.4 After
Low
being shown, 000000 will be displayed, use
,
ACC
,
UNIT
key to input low weight number
and press
TARE
key to confirm. Annunciator of
Lo
will be shown in this step or press
ZERO
key to exit
and back to weighing mode.
NOTE:
If High number is 0, equal or less than the low number, the comparison will be disabled, and the
input data has no limitation.
7.5 After the limitations have been set and check weight function is be active, one of annunciators
HI, OK, LO
will light up, and the beeper will sound according to its setting in
USER-BEEP
.
8. Count Weighing Mode
8.1 In this mode, scale will weigh goods weight on scale, calculate and display its counts after the piece
weight of goods is obtained
8.2 To make counting function be available,
CONFIG-FUNC-COUNT
item should be set to
YES
in
CONFIG
menu.
8.3 To enter counting working mode, in normal weighing or percent-weighing mode, long press
FUNC
key,
WEIGH/PERCEN
will be shown, use
ACC
or
key to select
COUNT
, then press
TARE
to confirm go
to parts counting mode. Before new piece weight is got, the last piece weight will be used.
8.4 In counting working mode, the function of
ZERO, TARE, PRINT, SETUP, PRESET TARE, ACC, SETUP,
ON/OFF
are available.
8.5 There’re two ways to obtain the piece weight: (1) input piece weight directly, refer operations of step 8.5.1
(2) weigh samples weight which quantity is known, refer operation of step 8.5.2
8.5.1 Input piece weight from keypad: in counting mode, press
UNIT
key, When
InP.PWt
is shown, press
TARE
key to enter input piece weight mode.
8.5.1.1 When
UNIT.KG
is shown, use
or
ACC
key to select the unit of piece weight, use
TARE
key to
