SKP-BC32HL POWER
CONTROLLER (E)
CE
13
1、
The switch mode SW5 change into ON.
※When SW5 change to ON, it will force to enter simulated learning procedure, any function will not work.
2、
When it changes to ON, LED will flash to let user know whether or not counting screws, starting slow-start, user must
be sure these essential condition then entering simulated learning.
- ------------------ ------------------- ---------------- -------------- -------CHECK
3、
When set up finish, LED will show 0.0, user can test about fastening screws, when screwdriver starts, LED will
count. When screwdriver shut-off, that means time to fasten screws. User can proceed many tests until satifaction.
User can change SW5 switch to OFF, the system will set up Lt/Ht time automatically.
4、
If user does not satisfy number, user can change SW5 to OFF, push SELECT over three seconds, entering menu to
change.
System procedure：
SL<SELECT>SC--<SELECT>--At--<SELECT>--Rc---<SELECT>--Ht--<SELECT>--Lt--<SELECT>LL--<SELECT>CHECK
When use Electric Screwdriver Controller, it should be grounded to avoid operator
getting electrical shock. This controller is equipped with 3 leading wires and 3 pins of
grounding plug to fit for grounding type of outlet. The grounding wire must be connected
firmly with power supply equipment for effective grounding result. The leading wire with
yellow-green color is a grounding wire. Never attempt to connect this yellow-green color
wire on electrified connector, this Controller has built-in grounding wire with electric
leakage safety grounding and additionally, the Controller can eliminate ESD static, which is
produced by running the electric screwdriver, via grounding wire.
Maintenance and Inspection :
1. The controller must be operated in top condition, one day working hour must be not
more than eight hours.
2. Please note don’t let the controller get over heated, every minute use 10~15 screws to
operate.
3. The frequency use of this electric screw driver is over eight hours a day, still it needs
8. Servicing
7. Grounding
ON
OFF
6. Simulated Learning
