Kikusui PAN 110-1.5A, Operation Manual

Page: 27 / 160

PAN-A 1-9
Chap
.1
Setup
1
■
Do not install the unit along a tilted section of fl oor or in a
location subject to vibrations.
If placed on a non-level surface or in a location subject to vibration,
the unit may fall, resulting in damage and injury.
■
Do not use the unit in locations affected by strong mag-
netic and/or electric
fi elds.
Operation in a location subject to magnetic or electric fi elds may
cause the unit to malfunction resulting in electrical shock or fi re.
1.4 Checking the input fuse
MODEL 350W/700W
Use an input fuse element suitable for the AC power source. A seal is
attached to the rear panel indicating suitable fuse ratings. See Fig.1-9.
• To avoid electric shock, always disconnect the AC
power code or turn off the switch on the switchboard.
• Select a fuse element of external design, rating and
characteristics suitable for the unit. Use of a fuse of
different rating or a short circuit of the fuse holder
may damage the unit.
Fig.1-9 Rear panel (model 350W)
WARNING
CAUTION
CONTROL
SENS
ON
OFF
S
S
1
2
7
8
13
14
19
OUTPUT
AC IN
FUSE
AC INPUT
100V 50/60Hz
REPLACE ONLY WITH
SAME TYPE AND
RATINGS OF FUSE.
WARNING
10A 125V/250V
WEIGHT Kg
MAX VA
Fuse holder
AC IN connector