6
4. Using the hand disinfectant dispenser
Dispensing is activated when the reflective sensor recognizes that hands have been placed near the
dispensing space. An electronically controlled pump dispenses hand disinfectant from the canister inside the
device. The hand disinfectant begins to be dispensed within 0.5 seconds after the sensor has detected the
hands. Dispensing stops after a programmed amount of hand disinfectant has been dispensed.
An overflow bowl at the bottom of the dispensing opening is connected to the waste fluid canister inside the
unit, which is where any excess hand disinfectant which might drip from hands is collected.
The hand disinfectant dispenser is used as follows:
1.
Place both hands side by side, palms up, in a cupped manner in the dispensing opening. The
sensor recognises hands from a distance of 6 to 10 cm. If hands are placed closer or further
than the above stated distance, the dispensing will not start.
2.
After dispensing a predetermined amount of hand disinfectant, the dispensing stops
automatically, and hands can be moved away from under the sensor. After the dispensing
finishes, disinfect hands by rubbing them carefully together until they are dry. If another
dispense is required, place hands again under the sensor as described in section 1.
NOTE! Hand disinfectant fluid must always be dispensed on both hands. Follow the hand disinfectant
instructions for wetting and cleaning hands carefully.
5. Inspecting and servicing the hand disinfectant dispenser
The required maintenance depends greatly on the amount of usage each individual unit receives. Under
normal operating conditions, a dispenser does not require any other maintenance than regular cleaning,
emptying the waste fluid canister and changing the hand disinfectant canister. However, the proper operation
of the unit must be checked regularly. It is suggested that a responsible person is nominated for checking the
routine and daily functioning of the unit.
5.1 Service and repairs
Do not hesitate to contact KiiltoClean or an authorised service centre for any repair advice or to send the
dispenser for servicing. KiiltoClean is not responsible for nor does the warranty cover breakdowns or
malfunctions caused by the customer's failure to follow the instructions described in this user manual.
NOTE! All service and maintenance procedures must be performed only when the dispenser is
disconnected from its electrical power supply. This is done by disconnecting the power transformer from the
electrical outlet.
5.1.1 Emptying the waste fluid canister
When the dispenser is in use, any hand disinfectant dripping from the hands collects in the overflow bowl
and is carried to the waste fluid canister, which is located inside the dispenser. It is important to monitor the
