4
3. Operating information
3.1 Safety guidelines
Use the hand disinfectant dispenser only under the following conditions:
•
All parts have been installed correctly and the device is fully operational
•
The hand disinfectant dispenser is used for its designated purpose and in an appropriate manner
•
The instructions in the user manual are followed
3.2 Preparing the hand disinfectant dispenser for use
3.2.1 Positioning the hand disinfectant dispenser
The Sa dispenser has been designed for indoor use only. The location must be easily accessible
from both sides. For example, place the hand disinfectant dispenser near the entrance of a building or a
cafeteria service line area.
Do not position the dispenser in a way that it blocks emergency exits, fire-fighting equipment or emergency
lighting. In addition, do not place the dispenser in locations where it would be exposed to continuous radiant
heat. Such places include near heaters, radiators or exposed to direct sunlight. This is very important as
otherwise the internal temperature may rise too high.
If the dispenser Is to be moved, handle it according to any local safety regulations. It is recommended that
two persons move the dispenser as it is heavy. Do not lift or move the unit by touching the section where the
sensor is located (where the hand disinfectant is dispensed). Move the dispenser only after disconnecting it
from the power source.
3.2.2 Mounting stand for the hand disinfectant dispenser
The dispenser must be mounted in an upright position on a flat level surface. The four adjustment knobs
underneath the dispenser are used to level the unit. Before moving the dispenser, take out both the hand
disinfectant canister and the waste fluid canister and secure the cover with the latch.
3.2.3 Installing the hand disinfectant canister
1. Use only hand disinfectants approved by KiiltoClean.
2. Open the cover using the triangular wrench supplied with the dispenser to turn the cover latch 45
degrees counter clockwise.
