37
Wood Parts
Hardware
Other Parts
Step 14: Rock Wall Assembly
A:
Lay 2 (0349) Rock Rails down, side by side with angled edges
facing down. (fig. 14.1)
B:
Place (2605) Access Board on the bottom of each (0349) Rock Rail
as shown in fig. (14.1). Make sure (2605) Access Board is flush to the
outside and bottom edges of each (0349). Attach using 4 (S2) #8 x
1-1/2” Wood Screws.
C:
7-5/8” down from the top of both (0349) Rock Rails place 1 (2604)
Rock Board B, making sure the sides are flush to the outside edges of
each (0349) Rock Rail. Attach using 4 (S2) #8 x 1-1/2” Wood Screws.
(fig. 14.1)
D:
In between the (2605) Access Board and (2604) Rock Board B
stagger 2 (2604) Rock Board Bs and 2 (2603) Rock Board As using 4
(S2) #8 x 1-1/2” Wood Screws per board. Placing them as shown in fig.
14.1, this will prevent rocks from forming a straight line. Make sure the
boards are evenly spaced and do not exceed 2-3/8” between boards.
E:
Place 1 rock on each (2603) Rock Board
A and (2604) Rock Board B (fig. 14.2) and
attach using 1 (PB2) 1/4 x 1-1/4” Pan Bolt
(with lock washer, flat washer and barrel nut)
and 1 (S10) #8 x 1” Pan Screw per rock. The
Screw must be in the hole directly under the
Pan Bolt, it will stop the rock from spinning.
(fig. 14.3)
Note: Gaps between boards 2-1/4”,
not to exceed 2-3/8”
Note: The holes
in the rock boards
must orient to the
top of the boards.
7-5/8”
Approx
Fig. 14.1
S2
2605
0349
2603
2604
2604
2604
2603
Fig. 14.2
1 x
Access Board 1 x 6 x 19-3/4”
3 x
Rock Board B 1 x 6 x 19-3/4”
2 x
Rock Board A 1 x 6 x 19-3/4”
2 x
Rock Rail 2 x 3 x 51”
24 x #8 x 1-1/2” Wood Screw
5 x
#8 x 1” Pan Screw
5 x
1/4 x 1-1/4 Pan Bolt
(1/4” lock washer, 3/16” flat washer & 1/4” barrel nut)
S2
0349
2603
2604
2605
3/16” Flat
Washer
1/4” Lock
Washer
1/4” Barrel
Nut
Rock
5 x Rocks (3 green/2 yellow)
S10
S10
PB2
PB2
Fig. 14.3
x 4 per
board
Summary of Contents for F24866
Page 94: ...94 NOTES...
