102
Step 46: Attach TNR2 Slide Exit to Exit Elbow Assembly
A:
Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR2 Slide Exit. (fig. 46.1)
B:
Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4
x 3/4” Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (fig. 46.2 and
46.3)
C:
At this point make sure all the slide bolts are tight.
Use a 7/16” open end wrench to hold nut and then
tighten bolt with Quadrex Driver on Clamp Rings.
Hardware
5 x
1/4 x 3/4” Pan Bolt
(1/4” lock nut)
PB1
Other Parts
1 x TNR2 Slide Exit
Fig. 46.3
Exit Elbow
Assembly
Bottom of Slide Views
Fig. 46.2
TNR2
Slide Exit
PB1
Lock
Nut
PB1
Lock
Nut
Start with
this bolt
Fig. 46.1
Slot of TNR2
Slide Exit
PB1
Summary of Contents for F23175
Page 111: ...111 NOTES...
