33
1 x
5/16 x 2-1/8” Wafer Bolt (5/16” flat washer, 5/16” t-nut)
1 x
1/4 x 2-1/2” Wafer Lag (5/16” flat washer)
1 x
#8 x 3” Wood Screw
2 x
#8 x 2” Wood Screw
Hardware
Wood Parts
1 x
SW Ground 5/4 x 4 x 14-1/4”
1 x
Diagonal 1-1/4 x 3 x 22”
090
091
Step 9: Attach SW Ground and Diagonal
A:
Loosely attach (090) SW Ground to (091) Diagonal with 1 (WB9) 5/16 x 2-1/8” Wafer Bolt (with flat washer
and t-nut) then place (091) Diagonal tight and flush to the front of (050) SW Wall Panel. (090) SW Ground to be
flush to the bottom of (050) SW Wall Panel. (fig. 9.1 and 9.2)
B:
Pre-drill pilot hole with a 3/16” drill bit then attach (091) Diagonal to (050) SW Wall Panel with 1 (WL5) 1/4 x
2-1/2” Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 9.1 and 9.2)
C:
Making sure bottom of (090) SW Ground is flush to bottom of (050) SW Wall Panel pre-drill with a 1/8” drill bit
then attach with 2 (S11) #8 x 2” Wood Screws and 1 (S4) #8 x 3” Wood Screw then tighten the bolt. (fig. 9.1 and
9.2)
5/16”
T-Nut
5/16” Flat
Washer
050
090
Fig. 9.1
Fig. 9.2
050
091
WL5
5/16” Flat
Washer
S11
S4
Flush
Flush
S11
S4
WB9
WL5
WB9
Summary of Contents for BROCKWELL
Page 101: ...101 NOTES...