22
To replace or install the batteries press on the battery carrier
and then release to allow the carrier to pop open. The battery
can then be pulled out of the carrier. When installing a new
battery into the carrier, make sure the battery terminals are
exposed and that the polarity matches the markings printed on
the battery carrier. Completely press the battery carrier down
into the alarm and release, the battery carrier will lock into the
closed position.
A missing or improperly installed battery will prevent the
battery carrier from closing and result in improper alarm
operation.
This smoke alarm uses a 9V battery. A fresh battery should last
for one year under normal operating conditions.
Replace batteries with one of the following approved brands:
Duracell MN1604,
MX1604
Energizer 522
and
Gold Peak 1604A.
These batteries can be purchased at your local retailer.
WARNING! Use only the batteries specified. Use of different
batteries may have a detrimental effect on the Smoke/CO
alarm. A good safety measure is to replace the battery at least
once a year, or at the same time you change your clocks for
daylight saving time.
rm Replacement
Ten years after initial power-up, this unit will “chirp” twice every
30 seconds to indicate that it is time to replace the alarm. A
label has been provided on the side of the alarm that has
“Replace by” printed on it. Write the replace by date on the
label. The date written on the label should be ten (10) years
after the alarm was initially powered.
Battery Replacement
Alarm Replacement
Summary of Contents for 900-0213CA
Page 1: ...E d d...
