Wire Routing
7. Snap loose the driver’s side front and rear threshold panel along the bottom of the door openings.
8. Remove the red battery terminal cover and then the power distribution cover next to the battery on the
passenger’s side.
9. Remove the fuse from the fuse holder on the amplifier and subwoofer power harnesses. Connect the ring
terminals of both harnesses to the power lug identified in figure 5 and torque to 9 +/- 1.5 Nm.
10. Route the power wire along the fire wall to the factory grommet on the driver’s side and secure with wire
ties.
11. Using a razor knife, make a cross shaped incision in the protrusion large rubber grommet and feed the
power wires straight through the hole on the cabin side of the grommet. Fig. 6
12. Install supplied connectors on the end of the power harnesses inside the cabin. It does not matter what
order the three wires are in on the white three pin connector but the terminal can only be inserted one way.
If the terminal will not go into the connector, simply turn it 180 degrees and try again. The black connector
should have a block out plug installed in one side to prevent the power wire from being installed into the
wrong position in the connector. Push the terminals in until they click and lock into place.
13. Connect the amplifier power harness three-pin connector to the amplifier harness three-pin connector.
14. Connect the subwoofer power harness two-pin connector to the subwoofer harness two-pin connector.
15. Connect the black ground wire of both the amplifier and
subwoofer harness to the bolt next to the park brake pedal
indicated in Fig 7 Torque to 9 +/- 1.5 Nm
16. Continue routing the subwoofer harness down the driver’s side of
the vehicle to the back wall. Open the cover of the wire tray
along the threshold of the door, install wire and replace the tray
cover.
17. Route the subwoofer harness under the carpet along the back
wall toward the passenger’s side of the cabin. Once the harness
is routed to the passenger’s side. Allow the remaining length of
harness to lay on top of the carpet and exit from beneath the seat
between the jack and the center seatbelt receptacle.
Fig. 5
Connect Power
wire(s) to this lug
Fig. 6
Fig. 7
Connect Ground
wire(s) to this bolt.
4
