Installation
1. Disconnect negative battery cable from battery. (For diesel engines with dual batteries disconnect both
negative cables)
2. Pry loose the radio bezel. Fig. 1
3. Remove the four screws securing the radio and HVAC controls. HVAC control wiring does not need to be
disconnected. Fig. 2
4. Route the amplifier harness from the radio opening down to the driver’s kick panel area. The white
connectors will connect to the amplifier.
5. Disconnect the radio speaker/power connector and connect it to the amplifier harness. Tuck the connector
out of the way. Fig. 3
6. Connect the remaining amplifier harness connector to the radio. Make sure the connector is fully seated.
Fig. 4
Fig. 1
Fig. 2
Fig. 3
Fig. 4
3
