9
61. Remove the jack and mounting plate and tape the paper template to the carpet lining up the three marks
with the corresponding markings on the template. Fig. 32
62. Cut the carpet along all the dotted lines on the template. When you are fi nished you will have two fl aps,
one large and one small. Pull back the two fl aps and cut away all the carpet insulation beneath. Fig. 33
63. Find the three pilot holes drilled earlier and drill a 17/32” hole at each location.
64. Install the supplied nut insert using an appropriate insert installation tool.
65. Secure the mounting plate with the supplied M8 bolts. Torque to 15ft/lbs.
66. Install the supplied adhesive covers over the holes in the fl oor pan where the jack used to mount to pre-
vent wanter from entering the cabin. Fig 34.
67.Route the subwoofer harness through the hole in the carpet where the jack was located closest to the
center of the truck. It’s important to route the harness through the hole closest to the center of the vehicle to
avoid interference with the subwoofer. 35.
Fig. 32
Fig. 33
Fig. 34
Fig. 35
Harness has
to exit from
beneath
carpet here.