8
52. Install the white three pin connector on the end of the amplifi er power harness inside the cabin. It does
not matter what order the three wires are in on the three pin connecter but the terminals can only be inserted
one way. If the terminal will not go into the connecter simply turn it 180 degrees and try again. Push the
terminals in until they click and lock into place. Install the black two pin connector on the end of the
subwoofer power harness inside the cabin. The black connector should have a block out plug installed in
one side to prevent the power wire from being inserted into the wrong position in the connector.
53. Connect the white three-pin connector of the amplifi er harness to the corresponding connector of the
amplifi er power harness.
54. Connect the black two-pin connecter of the power wire to the corresponding connector of the
subwoofer harness.
Subwoofer Installation
55. Connect the black ground wire of the subwoofer harness to
the factory ground point in the driver’s side kick panel. Torque to
9Nm. Fig. 29
56. Route the subwoofer harness along the door opening and
toward the rear of the cab.
57. Connect the white two-pin connector of the amplifi er harness
to the corresponding connector of the subwoofer harness.
Jack Relocation
58. Remove the three bolts securing the jack mounting plate.
59. Move the plate and jack to the passenger’s side rear seat area and push it back until the tool bag touch-
es the front of the seat frames. Make sure the jack mounting plate is oriented the same way it was originally
with two mounting holes toward the rear of the truck and one toward the front. Fig. 30
60. Measure over exactly seven inches from the inside of the seat frame to the edge of the jack mounting
plate. It is important that this measurement be accurate. Mark the three mounting holes with a marker and
then drill a 1/8 inch pilot hole in the center of each of the three mounting holes. Fig. 31
Fig. 29
Connect
black
ground
wire of
subwoofer
harness
Fig. 30
7 inches
Fig. 31