6
OPERATION
Automatic Turn-On Selection:
The KXMA series offers three different automatic turn-on modes that
can be selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio
mode causes the REM terminal to have +12V out for turning on additional amplifi ers.
•
Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit.
Run 18 gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM
between the amplifi er’s positive and negative power terminals. This is the preferred automatic turn-on
method.
•
DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC
Offset mode detects a 3V DC offset from the HI-Level speaker outputs when the source unit has
been turned on.
• Signal Sense Turn-On: The Audio setting is the fi nal alternative for Automatic turn-on. This is a
Signal Sense turn-on method that detects the incoming audio signal from your source unit and
automatically turns on the amp. This turn-on method will not work properly if the input gain control is
not set appropriately.
Fader Switch (500.4/800.4 Only):
Depress the fader switch if you are running two sets of inputs (front
and rear for example) to the amplifi er. Leave the fader switch OFF if you want to drive all channels from a
single stereo input.
Input Gain Control with Gain Matching:
The input gain control is not a volume control. It matches the
output of the source unit to the input level of the amplifi er and features Gain Matching to prevent clipping
the input. For a quick setup, turn the source unit up to about 3/4 volume (if the source unit goes to 30,
turn it to 25). KICKER recommends using the test tones at www.kicker.com/support/ to reach the most
accurate and best performing settings. Next, slowly turn (clockwise) the gain on the amplifi er up until you
see the Gain LED light up or hear audible distortion, then turn it down a little. If the GAIN knob’s backlight
comes on, the input is still clipping. For full instructions on Gain Matching, please see the next page.
Crossover Switches with Frequency Multiplier:
Use the XOVER switches on the end panel of
the amplifi er to set the internal crossovers of AMPS 1 & 2 to OFF, HI-PASS, LO-PASS, or BAND-PASS
(AMP 2 only). When the switch is set to
OFF
, a full bandwidth signal will be amplifi ed. Set the switch to
HP
if you want the amplifi er’s internal crossover to serve as a high-pass fi lter. Set the switch to
LP
if you
want the amplifi er’s internal crossover to serve as a low-pass fi lter. Set the switch to
BP
when a specifi c
frequency range is required. Never change the crossover switches with the audio system on!
Mini-USB for internal use only; do NOT remove or tamper. KICKER is not responsible for any damage to
equipment resulting from connections made to this port.
KXMA400.2
PRT
GAIN
11
0
500
10
500
40
6
0
OFF/HP/LP/BP
HI-PASS
LO-PASS
1X/10X
X-OVER
LO-PASS
RANGE
KICK EQ
Hz
Hz
dB
GAIN
MATCH
2021 KXM Stereo Amps Rev D.indd 6
6/28/2021 8:33:49 AM
Summary of Contents for KXMA Series
Page 11: ...2020 Stillwater Designs...
